3. Fill the hot tub to half way up the skimmer open-
ing. Note: If your hot tub is Hush Pump equipped
your level can be lowered to one third up the
skimmer opening.This will allow for more
displacement if the hot tub is subjected to use by
more than the recommended amount of people
for that model. See Figure 5.
WARNING!
Over filling will not allow room for displacement
from people entering the hot tub. Under filling could
cause an airlock in the system and could lead to
pump and heater damage not covered by your
guarantee.
4. Open the air bleed knobs to release any air
trapped in the external plumbing.There is one on
the 300 and 500 series hot tubs, two on a 500
series with Hush pump and a standard 700 series
and three on a 700 series with Hush pump. Once
all air is bled from the system, open any knife
valves that are facing down. See Figure 4.
5.Turn on your GFCI breaker.The circulation pump
will come on and the heater light or icon will
come on. If the fill water is colder than 50ºF /
10ºC, the pump(s) will go to high speed for 30
seconds, then back to low speed, then the heater
will come on.
Now that the hot tub is up and running and the
heater is on you need to check the settings and
possibly change them to suit your individual needs.
The default set temperature on all hot tubs is
100ºF / 37ºC.
On 300 series Digital systems, the only setting you
can adjust is the temperature.
On 500 series, you can adjust the temperature and
the amount of hours the hot tub filters, as well as
how many times a day the filter hours occur.
On 700 series, you can adjust temperature, amount
of hours the hot tub filters and a time clock that
needs to be set to your local time so the system
knows when to run the filter times.
Note: In the event of a power outage, the 300 and
500 series will default back to the factory filter and
temperature settings.
On 700 series the settings are backed up for 30
days and you will not have to reset once power is
back on.
Note: 700 series hot tubs with Hush Pump, the Hush
Pump will not resume 24 hour filtration until the
start of the next filter cycle.You can advance the
time clock 24 hrs if you do not want to wait until the
start of the next filter cycle.
WATER CARE PRODUCT STARTUP PROCEDURE
Follow these basic steps before entering the
hot tub.
Add a full bottle of Eliminate #1. Wait one hour.Add
2 oz/60 ml of Eliminate Plus #2.Add 3.5 oz/100 ml
of Purezyme #3. Wait 6 hours.
Add your sanitizer of choice.
Please note: Beachcomber offers several water care
programs to suit your needs; ask your dealer for a
tote card for those specific details - your startup
regimen may vary slightly. Beachcomber recom-
mends the following parameters for hot tub water:
pH Level 7.2 - 7.8
Sanitizer level
(chlorine or bromine) 3 - 5 ppm
Calcium Hardness 150 - 200 ppm
Total Alkalinity 100 - 120
Total Dissolved Solids not more than
1500 ppm
Your dealer may recommend slightly different levels
depending on your local source water. Please see
your dealer for more information by taking a water
sample in to be analyzed, or, check our website at:
www.beachcomberhottubs.com
- 3 -
Figure 5
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals