To replace a burned out bulb, turn off the power,
drain the hot tub, and unscrew the lens with the
wrench provided with your hot tub. Carefully pull out
the burned out bulb and then replace with a new
one. Screw the lens back in until tight. Do not over
tighten!
If the hot tub has the optional Everlite™ then, when
turned on it will cycle between the three colors, turn
off and on within 5 seconds and it will stop at one of
the colors. Continue turning off then on two pick one
of the other two colors. If left off for more than 10
seconds it will go back to cycling when turned on.
ACSS, (optional feature)
550x, 578 & 580 Model & 700 Series
AquaCoustic Surround Sound System™
This system is designed for lower level easy listen-
ing and not high volume levels which may disturb
neighbors.
The remote control is water resistant so if dropped
in the water momentarily it will not damage it. It is
not designed to be left in the water. Use the
remote storage shelf found at the top of the console
to store the remote when not in use.The remote will
not work from inside the hot tub if the console door
is open.The small plastic emitter affixed to the door
glass is the reason; it must be lined up with eye on
the deck for the remote to work from inside the hot
tub. Please refer to the CD player manual for further
information about the model CD player in your hot
tub. See remote control user instructions for detailed
operations.
Turbo (optional feature) 500 & 700 Series
The purpose of the turbo option is to increase the
amount of air that comes out of the jets.The benefit
is a slight increase in the feel of the jet pressure. On
700 series hot tubs the turbo has 3 speeds and on
500 series it only has a single speed. If the turbo is
activated and the air controls are closed, the air
from the turbo will come out of the 4 salt shaker
relief jets found in the foot well of the hot tub.
Ozone Generator (optional feature)
Installation of an ozone generator will reduce the
demand on your primary sanitizer which in turn will
reduce the frequency of sanitizer addition.It does
not replace your sanitizer.The ozone generator is a
black box mounted on the back wall of the equip-
ment area. It has a clear viewing window on the
right end.This window will show a purple glow from
the micro chip, when the ozone generator is on
during programmed filtering times.The purple glow
(best seen at night) is what produces the ozone gas.
Over time the purple glow will start to diminish to
the point no ozone is being produced.The output is
rated at 9000 hours. If your hot tub is in a pro-
grammed filter cycle time, not to be confused with a
heat demand cycle and no purple glow can be seen
you may need to replace the micro chip.
To replace the chip, turn off the breaker, unplug the
unit from the management system, disconnect the
braided line, remove the two screws holding it on
the equipment wall and turn over and remove the
three screws holding the back cover on. Unplug the
three wire connections and then install the new chip
in reverse order. New chips are available from your
local dealer. See Figure 9.
Hush Pump
The Hush pump is a very quiet, low amperage high
flow circulation pump that looks after the filter and
heating functions of your hot tub. It comes set from
the factory to operate 24 hours a day.This is the
recommended run time due to the energy efficiency
of it. If you desire less than 24 hour operation you
can reprogram it on your control panel. Be sure not
to decrease the run time to the point that you are
not getting enough hours of filtration a day to
maintain water clarity.
- 20 -
Figure 9
view window
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals