HOT TUB CARE AND MAINTENANCE
Filter Removal and Maintenance
The 25 sq ft. Microfilter in the hot tub should be
cleaned approximately every two weeks or more if
bather load is high. Failure to clean the filter can
result in cloudy water, odor and potential equipment
damage due to decreased flow.
To remove the filter, put the hot tub on stand-by (see
digital operation instructions for your model).
Stand-by prevents debris from the filter or objects
in the water from being sucked into the pump.
Note: The hot tub will stay in stand-by until either
the external freeze sensor detects 50ºF / 10ºC or the
temperature sensor senses a temperature more than
20ºF / 6ºC below set point.
To remove, twist the trim ring to unlock it and
remove with the floating weir assembly, then lift out
the basket and then pull out the filter. Remove any
hair or debris from the basket.
Soak the filter in a cleaner such as Filter Pure
overnight and then remove and rinse thoroughly
with a hose spray nozzle to remove cleaner residue.
It is recommended that you alternate filter cleaning
each month with Filter Cure. It is also advisable to
have two filters, install the spare filter while the
other is soaking in the cleaner.
Cleaning of the Acrylic Surface
The acrylic surface is very easy to maintain and care
for. Use Tub Clean to remove water level scum lines
and some warm water and a damp cloth to wipe
down the rest of the surface.
Never use a cleaner that contains ammonia.This
could damage your acrylic surface.Avoid leaving the
hot tub empty and the Acrylic exposed to hot sun.
Always put the Heatshield back on the hot tub.
Heatshield and Step Tops
As with any vinyl product that is exposed to the
weather, the better the care, the longer it will last.
Use a mild dish soap solution to remove dirt on the
cover and then treat the vinyl with Cover All.Avoid
application in the hot sun. Note: While the
Heatshield is strong enough to withstand up to 2
feet of snow it is not designed to support the weight
of children or pets walking on it or adults sitting
on it.This will break the foam inners and lead to
premature failure of the cover.
Hot tub Cabinetry and Steps
If your hot tub has natural cedar and you want to
keep it looking new, use Nu Wood Stain Clear once
a year.
If the cedar is weathered some, use Nu Wood
Natural or Twilight to bring back the color. Sanding
with 100 grit may be necessary if weathering is
advanced. If the cabinet is Enviroskirt™ simply
clean with a mild dish soap solution from time to
time.
Plastic Components
The jets should be removed periodically and rinsed
out to remove debris from the spinning assemblies.
If calcium build-up is present, soak the parts in
Filter Cure to loosen the calcium and then scrub
with a brush and hose off.
If a lot of hair and debris is present on suction
covers located in the foot well, this can reduce
water flow to the pumps. Manually remove when
the hot tub is empty or full.
- 18 -
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals