START UP
When your hot tub is first powered up, it begins
running in standard mode. Standard mode will
automatically heat and maintain 100°F / 37.5°C
until you change the set temperature. Pressing
the pad switches the hot tub to economy mode,
which is not recommended with a hush pump™ as
this circulation pump draws very little current and
is designed to operate 24 hours a day.
TIME
To set the time, press ,then .You will see the
words "SET TIME" flashing on the display Pressing
or once will begin changing the time in
one-minute increments. Press either pad to stop the
time from changing.TO scroll the time quickly,
briefly hold down either the or button and
then release.The time will change rapidly. Hit either
button to stop. Press to enter the correct time
into the system.
FILTER CYCLE PROGRAMMING
Due to the energy efficiency of the Hush Pump™
option, your hot tub is set to automatically filter itself
24 hours a day.Although there are other filter
durations, it is generally not necessary to change
this setting. Filter duration is programmable at the
topside panel. Press , , within 3 seconds.
"SET START FILTER 1" will appear on the display.
Press or to change filter 1 start time.When
"SET HEAT" is on the display, press "on" to
warm the water during filtering, or press "off"
to disable the heater. Press , to see "SET STOP
FILTER 1" and adjust the time with or as
done above. Press to see "SET START FILTER 2"
and proceed as above. Pressing will enter the
new filter cycle times into the system and display
the current water temperature.At the start of each
cycle, the turbo (if installed) will turn on for 30
seconds to clean out the air channel.
The ozone generator (if installed) will run for the
duration of the filter cycle. Note: if your hot tub is not
equipped with the Hush Pump the default filter
cycles will be 2:00 am to 4:00am for filter cycle one
and 2:00 pm to 4:00 pm.You may need to add time
to these cycles if bather load is high or frequent to
maintain water clarity.
TEMPERATURE ADJUSTMENT
(60°F-104°F) / (15°C-40°C)
Press either or once to display the last
temperature that was set. If either pad is pressed
within 3 seconds, the temperature setting will
increase or decrease in 1oF increments.Actual
water temperature will reappear on the display after
changing the temperature setting.
MASSAGE 1
Press the 1 pad once to activate the pump1’s low
speed, again for the pump’s high speed, and once
more to turn off the pump.The pump’s low speed
turns off after 1 hour.The pump’s high speed turns
off after 15 minutes of use.
- 13 -
DIGITAL SYSTEMS, PROGRAMMING, OPERATION AND ERROR MESSAGES
700 Series Digital 3000 System
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals